XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
New parts that we need Mr Hudy https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=21&t=7039 |
Page 1 of 2 |
Author: | D.Vale [ Sat Feb 02, 2008 01:24:23 ] |
Post subject: | New parts that we need Mr Hudy |
can we please have a hollow middle shaft and aluminum middle bearing block. |
Author: | grub [ Sat Feb 02, 2008 10:52:06 ] |
Post subject: | Re: New parts that we need Mr Hudy |
Author: | rx7ttlm [ Sat Feb 02, 2008 10:53:04 ] |
Post subject: | |
Author: | nunofilipe [ Sat Feb 02, 2008 12:09:55 ] |
Post subject: | Re: New parts that we need Mr Hudy |
Author: | _cyclops_ [ Sat Feb 02, 2008 13:11:39 ] |
Post subject: | |
Author: | Roelof [ Sat Feb 02, 2008 15:22:57 ] |
Post subject: | |
Author: | rx7ttlm [ Sun Feb 03, 2008 00:21:45 ] |
Post subject: | |
Author: | Roelof [ Sun Feb 03, 2008 09:41:16 ] |
Post subject: | |
A hollow middle shaft will only unbalance the car more if the servo's are on the opposite side...... Get a set of lightweight wheels from ATS. OK, still no balance but you do loose a lot of weight where you want it. 20 gram is nothing, just do not take any care of it, the weight of the much higher placed coolinghead of the engine is giving more influence on weighttransfer in corners than some grams on driveshaft hight. Get 4 small weightscales and you can move some weight with the springtension: |
Author: | rx7ttlm [ Sun Feb 03, 2008 13:50:00 ] |
Post subject: | |
Author: | _cyclops_ [ Sun Feb 03, 2008 16:09:25 ] |
Post subject: | |
Author: | Roelof [ Sun Feb 03, 2008 16:10:02 ] |
Post subject: | |
Author: | Roelof [ Sun Feb 03, 2008 16:18:26 ] |
Post subject: | |
Author: | CIMRI [ Wed Feb 27, 2008 11:48:10 ] |
Post subject: | |
Author: | ds motorsport [ Wed Feb 27, 2008 12:00:54 ] |
Post subject: | |
Author: | tomb [ Thu Feb 28, 2008 09:15:54 ] |
Post subject: | Re: New parts that we need Mr Hudy |
Author: | Dennison J [ Thu Feb 28, 2008 23:40:04 ] |
Post subject: | Re: New parts that we need Mr Hudy |
Author: | ds motorsport [ Sun Mar 02, 2008 16:00:06 ] |
Post subject: | |
Author: | tomb [ Sat Mar 08, 2008 16:57:55 ] |
Post subject: | |
Author: | CIMRI [ Sat Mar 08, 2008 20:18:57 ] |
Post subject: | |
Author: | Roelof [ Sat Mar 08, 2008 22:29:20 ] |
Post subject: | |
Page 1 of 2 | All times are UTC + 2 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |