the 2 at the same time
| XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
| traction roll https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=21&t=6938 |
Page 1 of 1 |
| Author: | leonard [ Thu Jan 17, 2008 20:35:07 ] |
| Post subject: | traction roll |
what is the real bennifit of the 4mm chassis and the mono block, can it help to avoid traction rolling?? |
|
| Author: | teamgp [ Thu Jan 17, 2008 21:56:32 ] |
| Post subject: | |
Take a look at . I'm not sure if it helps with traction rolling or not, other than to say that I have not had a problem with traction rolling since I've been using it. I started using it back in July on medium to VERY high bite tracks. |
|
| Author: | Martin Hudy [ Tue Jan 22, 2008 19:53:35 ] |
| Post subject: | |
Yes teamgp is right. 4mm chassis will give you more steering and also help you to get rid of traction roll. |
|
| Author: | muscma [ Thu Jan 24, 2008 13:27:28 ] |
| Post subject: | |
Martin, what do you use? The 4mm chassis or the Multi-Flex System? |
|
| Author: | leonard [ Thu Jan 24, 2008 19:07:46 ] |
| Post subject: | |
the 2 at the same time
|
|
| Author: | Martin Hudy [ Fri Jan 25, 2008 16:05:14 ] |
| Post subject: | |
I use 4mm chassis but not multi-flex. The reason is that I usually drive on high traction tracks where multi-flex is not necessary |
|
| Author: | _cyclops_ [ Fri Jan 25, 2008 20:37:39 ] |
| Post subject: | |
| Author: | leonard [ Fri Jan 25, 2008 20:51:15 ] |
| Post subject: | |
| Author: | rx7ttlm [ Fri Jan 25, 2008 21:32:49 ] |
| Post subject: | |
| Author: | ds motorsport [ Sat Jan 26, 2008 00:19:53 ] |
| Post subject: | |
| Author: | Martin Hudy [ Wed Feb 13, 2008 20:00:43 ] |
| Post subject: | |
| Page 1 of 1 | All times are UTC + 2 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|