XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
anyone using this part https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=21&t=6786 |
Page 1 of 1 |
Author: | ToysRUsKid [ Wed Dec 19, 2007 19:54:14 ] |
Post subject: | anyone using this part |
Author: | Roelof [ Wed Dec 19, 2007 20:22:27 ] |
Post subject: | |
Author: | ToysRUsKid [ Wed Dec 19, 2007 20:25:22 ] |
Post subject: | |
Author: | muscma [ Wed Dec 19, 2007 22:40:31 ] |
Post subject: | |
on Teemu Leino´s car |
Author: | ToysRUsKid [ Thu Dec 20, 2007 07:22:40 ] |
Post subject: | |
thanks, but i still can't see how it works. |
Author: | Roelof [ Thu Dec 20, 2007 09:27:04 ] |
Post subject: | |
Author: | ToysRUsKid [ Thu Dec 20, 2007 16:53:32 ] |
Post subject: | |
so i can tape a rx and a lipo regulator to this thing. i don't think they will fit in the box so i was looking into this. |
Author: | john r [ Sat Dec 22, 2007 03:11:30 ] |
Post subject: | |
Author: | ds motorsport [ Fri Dec 28, 2007 21:49:16 ] |
Post subject: | |
i use it, works ok but i think the reciever is exposed too much. So i bought a carbon sheet which you can fold and bend if you warm it up. This way i'm going to make a carbon box. |
Author: | john r [ Sat Dec 29, 2007 02:19:50 ] |
Post subject: | |
Author: | seachange [ Sun Jan 06, 2008 19:54:30 ] |
Post subject: | |
Page 1 of 1 | All times are UTC + 2 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |