XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
Pic of Correct body cut for good Air flow https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=21&t=6367 |
Page 1 of 1 |
Author: | HulkRay [ Tue Oct 09, 2007 23:51:00 ] |
Post subject: | Pic of Correct body cut for good Air flow |
Author: | Diatta Collymore [ Wed Oct 10, 2007 00:35:41 ] |
Post subject: | |
Some people cut out the whole rear windshield, and some people put a smaller hole on top for acces to the tank, and then one on the front windshield to direct airflow to the motor. As long as there is a hole in the front and rear you should be good. Also cut out the front windows ![]() |
Author: | HulkRay [ Wed Oct 10, 2007 00:40:25 ] |
Post subject: | |
Author: | brian hates nitro [ Wed Oct 10, 2007 02:06:38 ] |
Post subject: | |
Check out the EC results, look down at the various pictures especially the 1-2-3 podium. basically all cars are cut the way the one above is. |
Author: | HulkRay [ Wed Oct 10, 2007 02:36:55 ] |
Post subject: | |
Author: | Mark Christopher [ Wed Oct 10, 2007 09:19:36 ] |
Post subject: | |
Author: | HulkRay [ Wed Oct 10, 2007 10:24:17 ] |
Post subject: | |
Author: | Mark Christopher [ Wed Oct 10, 2007 11:11:10 ] |
Post subject: | |
Author: | trini [ Wed Oct 10, 2007 13:04:04 ] |
Post subject: | |
Author: | HulkRay [ Wed Oct 10, 2007 13:22:31 ] |
Post subject: | |
Author: | brian hates nitro [ Wed Oct 10, 2007 13:29:01 ] |
Post subject: | |
Author: | HulkRay [ Wed Oct 10, 2007 13:36:13 ] |
Post subject: | |
Author: | brian hates nitro [ Wed Oct 10, 2007 13:47:13 ] |
Post subject: | |
Author: | HulkRay [ Wed Oct 10, 2007 14:03:17 ] |
Post subject: | |
Author: | brian hates nitro [ Wed Oct 10, 2007 15:59:13 ] |
Post subject: | |
Author: | teambhr [ Mon Feb 04, 2008 06:58:35 ] |
Post subject: | |
what size are those holes? What did you use to cut the holes? |
Author: | D.Vale [ Tue Feb 05, 2008 00:00:31 ] |
Post subject: | |
front hole is about 60mm the rear window can be cut out completely is desired. With a circle cutter made by a company named olfa |
Author: | _cyclops_ [ Tue Feb 05, 2008 08:37:23 ] |
Post subject: | |
Author: | teambhr [ Tue Feb 05, 2008 23:28:20 ] |
Post subject: | |
what about ROAR what is th max size hole |
Author: | teamgp [ Wed Feb 06, 2008 00:00:43 ] |
Post subject: | |
Page 1 of 1 | All times are UTC + 2 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |