XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
clutch spacing https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=21&t=5800 |
Page 1 of 1 |
Author: | brian hates nitro [ Wed Jul 04, 2007 18:47:58 ] |
Post subject: | clutch spacing |
Author: | CIMRI [ Wed Jul 04, 2007 22:33:26 ] |
Post subject: | Re: clutch spacing |
Author: | brian hates nitro [ Thu Jul 05, 2007 01:27:34 ] |
Post subject: | |
Author: | brian hates nitro [ Fri Jul 06, 2007 13:57:48 ] |
Post subject: | |
Author: | Roelof [ Fri Jul 06, 2007 17:42:10 ] |
Post subject: | |
To create more gap within the limits of the crankshaft there are 2 options: 1) grind the flyweights a bit smaller, this is what I normally do, I make them 0.3mm thinner 2) make a shimring 3mm inside 5mm outside and place it on the top of the crankshaft before mounting the endpiece with axial bearing. |
Author: | CIMRI [ Fri Jul 06, 2007 23:48:32 ] |
Post subject: | shim |
Page 1 of 1 | All times are UTC + 2 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |