XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
Bearing seals https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=21&t=5599 |
Page 1 of 1 |
Author: | _cyclops_ [ Sun Jun 03, 2007 16:08:52 ] |
Post subject: | Bearing seals |
Author: | Roelof [ Sun Jun 03, 2007 17:58:38 ] |
Post subject: | |
Author: | calvin [ Mon Jun 04, 2007 07:01:13 ] |
Post subject: | |
Author: | _cyclops_ [ Mon Jun 04, 2007 08:35:44 ] |
Post subject: | |
Author: | mtveten [ Mon Jun 04, 2007 17:47:03 ] |
Post subject: | |
Author: | calvin [ Tue Jun 05, 2007 06:39:25 ] |
Post subject: | |
Mark, No, I haven't. I wanted something that was, in my mind at least, a little more "robust". I just can't offer you an opinion on those items such as the Integy unit, though other Integy products I have used in the past have been excellent. I can say that the one I use leaves a lot of crap at the bottom after I've finished cleaning; though admittedly I don't do much mechanical cleaning prior to putting the bearings in the unit - just a quick wipe with a rag to take off any built up stuff. I think one of the most important parts of my procedure is using the ultrasonic unit in the oiling process since I don't remove the seals. |
Author: | trini [ Tue Jun 19, 2007 17:24:22 ] |
Post subject: | Bearing Spares |
Author: | mtveten [ Tue Jun 19, 2007 18:24:00 ] |
Post subject: | |
Author: | _cyclops_ [ Tue Jun 19, 2007 20:06:58 ] |
Post subject: | |
Page 1 of 1 | All times are UTC + 2 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |