XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
Carb linkage problem https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=21&t=5494 |
Page 1 of 1 |
Author: | Salinet [ Tue May 15, 2007 23:14:25 ] |
Post subject: | Carb linkage problem |
Hi, I think I found a problem on the instructions manual. Carb Linkage (page 31) The instruction show the screws on top going through the servo horn to tight on a plastic piece. But this piece had a 3mm hole and we must use a 3mm screws so the screws pass through it! I think the right way is insert the screw on the bottom of that plastic piece and them tight it on the servo horn. Please...... Am I right? Help me with thins problem. Regards to all Flavio FS MODELSPORT XRAY TEAM BRASIL |
Author: | HulkRay [ Tue May 15, 2007 23:52:28 ] |
Post subject: | Re: Carb linkage problem |
Author: | Salinet [ Wed May 16, 2007 14:45:42 ] |
Post subject: | |
Author: | trini [ Wed May 16, 2007 16:22:01 ] |
Post subject: | |
Page 1 of 1 | All times are UTC + 2 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |