| XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
| NT1 Ackermann - Confusion in documentation https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=21&t=5449 |
Page 1 of 1 |
| Author: | PDX-Spike [ Wed May 09, 2007 10:03:37 ] |
| Post subject: | NT1 Ackermann - Confusion in documentation |
| Author: | althea [ Wed May 09, 2007 15:23:17 ] |
| Post subject: | |
| Author: | PDX-Spike [ Wed May 09, 2007 17:44:01 ] |
| Post subject: | |
| Author: | althea [ Wed May 09, 2007 19:59:36 ] |
| Post subject: | |
OK, if the distance "A" is greater (see pic) - less ackerman effect (steering rods angled more), if distance "A" is smaller, you'll have more ackerman effect (steering rods are angled less). Also, the ackerman insert illustration on page 33 is correct, it's little confusing 'cause the picture to the left (and the two on the bottom) should be rotated 180 degrees to match the insert illustration. Hope I didn't confuse you even more 
|
|
| Author: | PDX-Spike [ Wed May 09, 2007 23:18:50 ] |
| Post subject: | |
Ok, I understand. The illustration of the four settings is correct if you're looking at the servo saver from the rear of the car. So the Instruction Manual setting is for "more" Ackermann. Thanks for the clarification and explanation of the Ackermann settings. |
|
| Author: | rmdhawaii [ Thu May 10, 2007 09:48:28 ] |
| Post subject: | Re: NT1 Ackermann - Confusion in documentation |
| Author: | trini [ Thu May 10, 2007 14:04:46 ] |
| Post subject: | |
| Author: | PDX-Spike [ Thu May 10, 2007 19:11:34 ] |
| Post subject: | |
| Author: | trini [ Thu May 10, 2007 21:44:45 ] |
| Post subject: | |
| Page 1 of 1 | All times are UTC + 2 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|