Great Tim Thanks alot
| XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
| Steering Tips https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=21&t=5422 |
Page 1 of 1 |
| Author: | trini [ Mon May 07, 2007 11:45:46 ] |
| Post subject: | Steering Tips |
Guys can you share you tips on attaching the steering linkage to the servo saver. I am just getting the linkage to rest on the saver which is causing it to touch the top chassis, how to I get it to screw down onto the servo saver screw. thanks |
|
| Author: | ChrisP [ Mon May 07, 2007 13:31:10 ] |
| Post subject: | |
The linkage should be below the servo saver. |
|
| Author: | trini [ Mon May 07, 2007 13:42:18 ] |
| Post subject: | |
Ok, because from the manual it shows the linkage being placed onto the servo saver. |
|
| Author: | Tim Mckay [ Mon May 07, 2007 13:56:20 ] |
| Post subject: | |
Do you mean the linkage from the steering servo when its attached to the servo saver is hitting the top chassis plate ? Or is it the Linkages that go from Servo Saver to the front hubs ? If its the linkage from steering servo make sure its the coprrect length, even then it shouldnt hit the top plate as on my car theres probably 3-4mm clearance. |
|
| Author: | trini [ Mon May 07, 2007 14:16:46 ] |
| Post subject: | |
Yes, the steering linkage, should it be screwed down onto the steering servo saver or should it just rest on it. On resting on it it touches the chassis when I turn the wheels to the extreme left, the linkage goes foward and grinds the chassis. If I need to screw it down to the servo saver how do I get to the screw to do such an act? Length correct just measured it again with a caliper and against the manual thanks again |
|
| Author: | Tim Mckay [ Mon May 07, 2007 14:22:51 ] |
| Post subject: | |
Yes, You screw it down so its hard against the servo saver. On the servo saver there should be the 3x10mm screw thats screwed in from the bottom of the servo saver and there should be about 2-3mm sticker out on top. Now on the linkage from servo, on the end of the linkage should be plastic end and a pivot ball inside it. All u need is a 3mm hex Driver and make sure the pivot ball is the right way so the end that the 3mm hex driver goes into is on top. Then just line up the pivot ball with the bolt thats sticking out of servo saver and tighten it until its tight. |
|
| Author: | trini [ Mon May 07, 2007 14:25:02 ] |
| Post subject: | |
Great Tim Thanks alot
|
|
| Author: | ChrisP [ Mon May 07, 2007 23:36:45 ] |
| Post subject: | |
Thanks for the clarification Tim... 
|
|
| Author: | trini [ Tue May 08, 2007 04:12:39 ] |
| Post subject: | |
| Page 1 of 1 | All times are UTC + 2 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|