XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
sway bar eccentrics ? https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=21&t=5412 |
Page 1 of 1 |
Author: | Alan Lunghi [ Sat May 05, 2007 18:50:57 ] |
Post subject: | sway bar eccentrics ? |
on the front sway bar mounts there are the eccentrics adjusters . what is the procedure for adjusting them . and what should they be adjusted at the set up manual and instruction manual dont go into these adjustments. thanks in advance alan |
Author: | Lycan [ Sun May 06, 2007 10:39:39 ] |
Post subject: | |
disconnect shocks and swaybar. Place car on setup blocks, measure droop. Reconnect swaybar and re-check droop. The sway bar should not change the droop levels. If it does, use ecentric adjusters to correct the problem. |
Author: | brano [ Wed May 09, 2007 13:56:20 ] |
Post subject: | |
On page 22 of the NT1 Set-up Book, you use the front anti-roll bar eccentric adjusters to combat front tweak. If the front anti-roll bar is causing tweak, you adjust one (or both eccentrics to eliminate front tweak. During initial assembly, you can orient both adjusters so they are horizontal (pointing to outsides). |
Page 1 of 1 | All times are UTC + 2 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |