XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
Stripping 1 gear https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=21&t=18725 |
Page 1 of 1 |
Author: | Mijo-dk [ Thu Jun 26, 2014 06:52:11 ] |
Post subject: | Stripping 1 gear |
Hi Have anyone had any problems with stripping the 1 gear? I have changed the oneway adapter , use the hudy oneway oil , give it one drop every 30 min. Have stripped around 10 1 gears , both 59 and 60. Car is NT1 2014. Any ideas |
Author: | Thilo-Alexander [ Thu Jun 26, 2014 10:45:49 ] |
Post subject: | Re: Stripping 1 gear |
No, never striped a gear, not once. Mybe your clearance between the Pinion and Spur is seriously wrong? When does this happen? Greetings Thilo |
Author: | Mijo-dk [ Fri Jun 27, 2014 04:56:29 ] |
Post subject: | Re: Stripping 1 gear |
No , clearence is perfect. Have so far changed : Pinion - spur - one way bearing unit - 2 speed axle bearing - bearing clutch - bearing engine And still it strip the gear. I give the oneway bearing one drop of oneway oil (the hudy one) every 30 min. Now we will change the 2 speed axle. |
Author: | Roelof [ Sun Jun 29, 2014 11:31:53 ] |
Post subject: | Re: Stripping 1 gear |
Also check if the crankshaft is straight. When mounted in the car use a hex driver to turn the engine round slowly and check the gear mesh if it changes. |
Author: | HartmutRose [ Sun Jun 29, 2014 19:12:40 ] |
Post subject: | Re: Stripping 1 gear |
There are three thinks, you can looking for: 1) Do you have a lightweight 2-speed-axle? A newer one do not work properly. 2) The Bearings in the clutch are o.k.? 3) Make sure, that the screw´s from the gear box shoe´s is not to tighten. Greet´s Hartmut |
Page 1 of 1 | All times are UTC + 2 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |