| XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
| brace motor - roll center position https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=21&t=13642 |
Page 1 of 1 |
| Author: | massi1309 [ Wed Aug 21, 2013 12:26:31 ] |
| Post subject: | brace motor - roll center position |
hello, I saw in the set up you use the link in support of the engine ahead. what is it? you have to install some optional parts? in that way, the behavior of the machine by raising the roll center in the rear platen carbon? Starting from the base all internal bottom. thanks |
|
| Author: | Hagberg [ Tue Aug 27, 2013 11:35:03 ] |
| Post subject: | Re: brace motor - roll center position |
Instead of the standard plastic piece which acts as a stiffener between the rear bulkhead and radio plate mounts, we can use a camberlink there, which allows more sideways movement of the chassis. Many team drivers use this option. Lately we have even tried to remove it completely for a lot more flex. |
|
| Author: | massi1309 [ Tue Aug 27, 2013 16:31:18 ] |
| Post subject: | Re: brace motor - roll center position |
What is a camberlink? photos or code xray? the behavior of the machine by raising the roll center in the rear platen carbon? Starting from the base all internal bottom. |
|
| Author: | Roelof [ Wed Aug 28, 2013 00:20:56 ] |
| Post subject: | Re: brace motor - roll center position |
The rear upper arms which are actually turnbuckles, that is a camber link. |
|
| Page 1 of 1 | All times are UTC + 2 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|