XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
Axle Shafts Play ! HELP ! https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=21&t=13108 |
Page 1 of 1 |
Author: | Italdesign [ Tue Nov 20, 2012 18:38:04 ] |
Post subject: | Axle Shafts Play ! HELP ! |
Hello, I have a Problem with my NT1 2012 Spec. Each wheel has play. I have axial play, The whole shaft with the wheel moves back and forth. The trackwidth can not be set correctly. Do I fit between the inner bearing and the drive shaft washers? The wheel hubs are fitted correctly, the shaft can be moved anyway. Thx for Help ! |
Author: | djiewie [ Mon Dec 10, 2012 12:00:22 ] |
Post subject: | Re: Axle Shafts Play ! HELP ! |
I removed the play with washers 0,1mm. The axial play back en forward was very little with my car. The original parts have little play when new. I fitted them on the inside. But make sure you still have a very little play with the washers. Make sure the bearings don`t have too much play. They should fit thight in the hubs. The cvd should fit thight also in the bearings. Thight = slides in with a little resistance. Hope this helps you allthough its a little late to reply. i`m not that often on line. |
Author: | Hagberg [ Mon Dec 24, 2012 01:18:53 ] |
Post subject: | Re: Axle Shafts Play ! HELP ! |
A little bit of play (0.5-1mm) is nothing to worry about. You will not notice a big difference on the track. A nitro powered car like the NT1 already has so much vibration from the engine. Many other things have a bigger influence on handling. |
Page 1 of 1 | All times are UTC + 2 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |