XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
Gear mesh https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=21&t=12121 |
Page 1 of 1 |
Author: | glennbarn [ Fri Jan 06, 2012 06:58:40 ] |
Post subject: | Gear mesh |
Hi all, At step 4, when i tighten the lower mount screws to the chassis from underneath, there seems to be no ability to adjust the mesh. I can only tighten the screws, and there isn't any play, and everytime i tighten, the gears are always set too tight. Then when i blip the throttle, the drivetrain, not under any break, just slows and stops, without free wheeling, because i think the gears are set too tight, and i think they're giving a slight hum/rip sort of sound. Please help on how i can loosen things up on the gear mesh side of things. I can't see how any of the steps allows me to loosen the mesh... thanks |
Author: | Mark Christopher [ Fri Jan 06, 2012 09:15:42 ] |
Post subject: | Re: Gear mesh |
Loosen the bolts that hold the engine to the mounts, you do not need to move it much . |
Author: | glennbarn [ Tue Jan 10, 2012 12:37:41 ] |
Post subject: | Re: Gear mesh |
For the record, undoing and redoing the screws between the engine and upper mounts has corrected the problem. Thanks for this. The instructions perhaps require a note on this. |
Page 1 of 1 | All times are UTC + 2 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |