XRAY - Model racing cars

Hi all,

At step 4, when i tighten the lower mount screws to the chassis from underneath, there seems to be no ability to adjust the mesh.

I can only tighten the screws, and there isn't any play, and everytime i tighten, the gears are always set too tight.

Then when i blip the throttle, the drivetrain, not under any break, just slows and stops, without free wheeling, because i think the gears are set too tight, and i think they're giving a slight hum/rip sort of sound.

Please help on how i can loosen things up on the gear mesh side of things. I can't see how any of the steps allows me to loosen the mesh...

thanks

Loosen the bolts that hold the engine to the mounts, you do not need to move it much .

For the record, undoing and redoing the screws between the engine and upper mounts has corrected the problem.

Thanks for this.

The instructions perhaps require a note on this.