XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
steering setup and making the car track perfectly straight https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=21&t=11597 |
Page 1 of 1 |
Author: | swiftly [ Sat Jul 30, 2011 08:43:14 ] |
Post subject: | steering setup and making the car track perfectly straight |
Hi what is the sequence for setting up the steering in relation to the tie rod links and the camber and so fourth to get a good tracking car correctly.. thanks |
Author: | Mark Christopher [ Sat Jul 30, 2011 11:57:25 ] |
Post subject: | Re: steering setup and making the car track perfectly straig |
Set spring pre load to correct ride hieght with race Tyres on. Measure the hubs are all the same distance between hub and wishbone you can also check from centre of car to each hub. Do this front and rear. Mount on hudy set up gauges and make same adjustments each side. To keep each hub equal. Set camber do front with radio and rx on., with the pivot ball suspension. I have seen many cars set up wrong and crabing and unequal turning. |
Author: | swiftly [ Sun Jul 31, 2011 08:36:23 ] |
Post subject: | Re: steering setup and making the car track perfectly straig |
ok i will try tht when i frist mount my servo on u want to be in tht 90 degree range, which it is never perfect so i assume u use sub trim to make it 90 ish, so did i just keep the rod lenght from the servo to servo saver to what xray specs and and same with tie rods then use sub trim on setup board to center the tire then set my toe. sorry mark i put camber in but i meant more of the relation to the toe of the car. |
Page 1 of 1 | All times are UTC + 2 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |