| XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
| Ride height https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=21&t=11453 |
Page 1 of 1 |
| Author: | Jacky38 [ Wed Jun 01, 2011 07:41:29 ] |
| Post subject: | Ride height |
Hello How did you regulate the ride height on your NT1 *- with blank rims *- with Aluminium Set Up Wheel *- with wheels D= 61 & 63 mm for example *- Other solution ? Thank you Jacques |
|
| Author: | Andrew Webber [ Fri Jun 03, 2011 08:38:47 ] |
| Post subject: | Re: Ride height |
U need a system that gives you consistancy. Measuring ride height after a race with worn foams tells you nothing. I use 61mm fronts and 63mm rears (old set of foams) specifically for measuring my ride height. I always adjust it with these wheels on the car. |
|
| Author: | Hagberg [ Tue Jun 14, 2011 18:36:57 ] |
| Post subject: | Re: Ride height |
With blank rims, usually 1mm front and rear basic ride height. |
|
| Author: | mariospiniello [ Mon Jun 20, 2011 09:25:07 ] |
| Post subject: | Re: Ride height |
I Use 56mm tires and my height is 4 mm on rear and 3.8 mm on front. |
|
| Author: | Pahissa [ Mon Jul 11, 2011 17:43:52 ] |
| Post subject: | Re: Ride height |
you can always use a set of rims to adjust ride hight, specially for mains. if you leave 1mm just with rims you make sure that the car will not end up with out suspension travell or with the chasis touching the surface. I specially do it like this when tire wear is a real concern... if not using tires at 61 & 63mm is fine. Just have to make sure that first you adjust ride hight and then camber. If you change ride height camber will also change and so performance of the car. |
|
| Page 1 of 1 | All times are UTC + 2 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|