| XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
| Alu shock absorber set for NT1 WE https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=21&t=11121 |
Page 1 of 1 |
| Author: | Jacky38 [ Tue Feb 08, 2011 09:19:33 ] |
| Post subject: | Alu shock absorber set for NT1 WE |
Hello On this shock absorber , on bottom side , we have the choice between two sealing 2 O-ring and 2 thin shim or 1 O-ring 1 thin shin and 1 thick shim. which is the difference between these 2 assembly. Which is the best thank you Jacky |
|
| Author: | Roelof [ Tue Feb 08, 2011 11:23:03 ] |
| Post subject: | Re: Alu shock absorber set for NT1 WE |
1 O-ring has less friction so it will react faster and better on a smooth but still a little bit bumby surface. The chance of a leak is bigger with one O-ring.... |
|
| Author: | Jacky38 [ Tue Feb 08, 2011 11:45:39 ] |
| Post subject: | Re: Alu shock absorber set for NT1 WE |
Thank you Roelof but i haven't the choise , there is only 4 O-ring in my kit |
|
| Author: | Mark Christopher [ Tue Feb 08, 2011 21:08:17 ] |
| Post subject: | Re: Alu shock absorber set for NT1 WE |
That's correct if you want two seals you need to buy more o rings |
|
| Author: | Hagberg [ Fri Feb 11, 2011 01:53:45 ] |
| Post subject: | Re: Alu shock absorber set for NT1 WE |
1 o-ring set-up is more smooth and this is always the best option. |
|
| Page 1 of 1 | All times are UTC + 2 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|