| XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
| Receiver on/off switch https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=21&t=10540 |
Page 1 of 1 |
| Author: | glennbarn [ Sun Jun 06, 2010 07:08:46 ] |
| Post subject: | Receiver on/off switch |
The on/off switch that came with my Radio Kit, Spektrum DX3R, is too big to fit in the receiver box where the on/off switch is meant to be mounted. Is there a specific Xray smaller or mini on/off switch? Also, so i can get my electric wires as neatly tucked away as possible, for ease of cleaning my car later etc, has anyone got any pics of how their cables are run around their car etc?? (To the moderators - perhaps this might be a simple little extra sketch type drawing that Xray could include on their next update to the instruction manual...sure i'm gonna do the best i can, just though it might be something that can help to add as 'best practice' etc) Thanks everyone in advance for their replies. |
|
| Author: | glennbarn [ Sun Jun 06, 2010 07:36:04 ] |
| Post subject: | Re: Receiver on/off switch |
Forgive me...newbie to NT1...just found it, part 33 6060 "Receiver Switch - Set". Still, if anyone has any close up pics of their electrical wiring layout, that would be great...thanks! |
|
| Author: | Roelof [ Sun Jun 06, 2010 11:44:21 ] |
| Post subject: | Re: Receiver on/off switch |
Most drivers do not use a switch but only a male/female servo or BEC plug. A bad switch is mostly the cause of glitches etc. so most do not use them. |
|
| Page 1 of 1 | All times are UTC + 2 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|