XRAY - Model racing cars

Has anyone run it with either the front lower arms in the optional forward position vs the standard rearwards position? I built my 2013 with the arms all the way forward like I did with the 2012 and the front blade sway bar, but the new wire sway bar is causing the arms to sit up a little and not fall all the way to the downstops. I wondered if this is caused by the position off the arms and the angle the linkage is on as a result?

try adjusting the length of the turnbuckles that hold the swaybar. if the arms are in the forward position the swaybar will sit higher so you may need to take some plastic off the turnbuckles to make them lower. i hope this helps

Hi John

Thanks for reply, I have since discovered that the sway bar is tweaked quite a bit so I have changed back to the blade for now.

Andrew