XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
Problems starting NT18 engine https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=18&t=8438 |
Page 1 of 1 |
Author: | nitzerebb [ Wed Nov 05, 2008 10:13:55 ] |
Post subject: | Problems starting NT18 engine |
Author: | matt_xb8r [ Wed Nov 05, 2008 16:57:25 ] |
Post subject: | |
Author: | nitzerebb [ Wed Nov 05, 2008 18:10:00 ] |
Post subject: | |
Author: | matt_xb8r [ Wed Nov 05, 2008 19:05:58 ] |
Post subject: | |
Author: | nitzerebb [ Wed Nov 05, 2008 19:19:13 ] |
Post subject: | |
Author: | matt_xb8r [ Thu Nov 06, 2008 00:19:59 ] |
Post subject: | |
Author: | nitzerebb [ Thu Nov 06, 2008 15:31:40 ] |
Post subject: | |
Hey Matt, yes, that's different to my settings... I'll test it later, when I'm at home Thank you so far |
Author: | geezatec [ Fri Nov 07, 2008 07:42:48 ] |
Post subject: | |
While cranking Fuel line to carb, does it fill up with fuel? Plug up the stinger of exhaust pipe with your finger until fuel fill up the line to carb while cranking. Assuming your igniter is good & glowplug. Make sure the starterbox is cranking the correct direction. Direction is CCW(counterclockwise) on flywheel from looking from the rear of the model. Even with it cranking the wrong direction it will start with lack of power. |
Author: | nitzerebb [ Fri Nov 07, 2008 09:47:49 ] |
Post subject: | |
Author: | Roelof [ Fri Nov 07, 2008 11:17:13 ] |
Post subject: | |
Author: | nitzerebb [ Fri Nov 07, 2008 12:00:32 ] |
Post subject: | |
Author: | nitzerebb [ Fri Nov 07, 2008 20:16:18 ] |
Post subject: | |
Author: | matt_xb8r [ Fri Nov 07, 2008 21:37:44 ] |
Post subject: | |
Page 1 of 1 | All times are UTC + 2 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |