XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
Fuel bubbles in tank https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=18&t=7845 |
Page 1 of 1 |
Author: | jonco [ Fri Jun 13, 2008 23:08:25 ] |
Post subject: | Fuel bubbles in tank |
Author: | Krolleg [ Sat Jun 14, 2008 10:36:19 ] |
Post subject: | Re: Fuel bubbles in tank |
Author: | jonco [ Sat Jun 14, 2008 11:36:42 ] |
Post subject: | |
Author: | Krolleg [ Sat Jun 14, 2008 12:26:53 ] |
Post subject: | |
Author: | geezatec [ Sat Jun 14, 2008 19:56:13 ] |
Post subject: | |
Author: | jonco [ Sun Jun 15, 2008 12:55:38 ] |
Post subject: | |
Author: | jonco [ Wed Jun 18, 2008 12:15:32 ] |
Post subject: | |
I was also using 25% fuel and then I read here that we should be using 16% Is it too late to change back to 16% Have I caused some damage already to the engine? I'm afraid if I go to 16% my truck will run slower ![]() |
Author: | Roelof [ Wed Jun 18, 2008 15:43:55 ] |
Post subject: | |
The engine runs fine on 25% and no it is not to late to switch over. I think you will not see the difference in performance than only a bit slower acceleration. Bubbles in the tank can be caused when the tank has a tight fit on the chassis. Be sure you have the rubber O-rings under the tank and dit not tighten the screws a lot, it will damp the vibrations. |
Author: | geezatec [ Wed Jun 18, 2008 17:02:43 ] |
Post subject: | |
Page 1 of 1 | All times are UTC + 2 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |