XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
What are dimensions of carburetor retainer nut? https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=18&t=5977 |
Page 1 of 1 |
Author: | CustomX [ Fri Aug 10, 2007 07:22:52 ] |
Post subject: | What are dimensions of carburetor retainer nut? |
I was wondering what the dimensions of the nut were at the end of the carburetor retainer rod for the NT18 engine/carburetor? This nut is part of the NT18 engine parts #616201. Thank You |
Author: | geezatec [ Mon Aug 13, 2007 18:38:44 ] |
Post subject: | |
Change the Toki to Picco-0. Toki, Trinity/Drake & Picco-0 The three in the class of 16 & 18 scales. probably the same. It is slightly larger the the exhaust manifold bolt, which are 2.5mm. The Picco is slightly larger & 3mm. So I believe 3mm nut will do. |
Page 1 of 1 | All times are UTC + 2 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |