XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
worn parts after 12 liter og fuel https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=18&t=4239 |
Page 1 of 1 |
Author: | kant76 [ Mon Sep 18, 2006 08:40:50 ] |
Post subject: | worn parts after 12 liter og fuel |
last night I took mt nt18 appart because the season hav ended. I found a gooa amount of wear on some parts, and some have to be replaced be4 next season. here goes: engine: piston sleve worn out almost (i´m gona replae the hole engine) center shaft: worn in both ends, almost round( maby xray can make one in a different alloy or carbon brake parts: fredos and activation rod(act rod almost worn ? way thrug) upper front a arms: outer ball almostworn to point were it will fallout. bottom plate: just worn out(normal wear) servo´s: both servos have alot of play in the out putshaft clutch & springs: worn compleatly down thats if have you got the same exp.? otherwise it have been the bedst nitro car I have raced for a season, the only thing that have been breaking down this season in one set of clutchsprings. very good job xray. keep it up |
Author: | Mini_Me [ Tue Sep 19, 2006 00:06:22 ] |
Post subject: | |
Author: | geezatec [ Tue Sep 19, 2006 08:23:08 ] |
Post subject: | |
All the consumeable items you pointed out were replaced plus these: Frt & rear pinion gears/shafts Frt one-way output shafts Adjustable ball diffs disassembled and maintenane done. Replaced all bearing needed Sevos were changed from the beginning. Xray stock servos didnt last after break-in. Hitec 85MG/BB/HT/HS were installed. Differance, they have Ball Bearing on te output shafts. Only one other mod was done. Adding a 6 cell NiMh AAA Battery pack was added. Been lucky with the Toki engine. After 5 1/2 gallons of fuel. It's still running strong. W/good compression. Waiting for it to wear out. Nickle Plated Pivot Balls were installed 1 1/2 gallons ago. to early to say. I think thet will last as long as the model |
Author: | kant76 [ Tue Sep 19, 2006 10:41:18 ] |
Post subject: | |
ofcourse the bearings needs to be replaced the nickel coated pivoballs have been installed since my lhs got them. but the upper arms have realy worn any way |
Author: | geezatec [ Tue Sep 19, 2006 19:08:07 ] |
Post subject: | |
'A' arm, was it in the rear, it wore out??? It took me a while to free up the bind to had. The rear doesnt move as much as the frt does. Same with the M18 I just assembled. I t does move as much. I'll let you know when I find out. |
Author: | kant76 [ Tue Sep 19, 2006 23:41:24 ] |
Post subject: | |
Author: | kant76 [ Tue Sep 19, 2006 23:43:37 ] |
Post subject: | |
Page 1 of 1 | All times are UTC + 2 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |