XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
New member with a NT18 https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=18&t=3956 |
Page 1 of 1 |
Author: | WerxRacing [ Fri Jul 28, 2006 00:34:59 ] |
Post subject: | New member with a NT18 |
Author: | WerxRacing [ Sat Jul 29, 2006 22:24:50 ] |
Post subject: | |
OK, 32people took a look, but no one can say HI or give good advice on fixing my NT18 up...........? Later. |
Author: | geezatec [ Sat Jul 29, 2006 23:03:35 ] |
Post subject: | |
Author: | WerxRacing [ Sun Jul 30, 2006 03:48:33 ] |
Post subject: | |
Great info. I will have my car here in a few days. I just got a HPI Mustang Cobra body for it & going to start from there. I'm in Southern Indiana. I was thinking of going with sealed ceramic bearing to inprove speed & long life on it. |
Author: | geezatec [ Sun Jul 30, 2006 06:41:20 ] |
Post subject: | |
Kewl!! Ceramic brgs nice. I just had bad luck with them, on my Serpent 960. When they break. total failure. I wont use them again. My opinion only. It's cool!! |
Author: | WerxRacing [ Sun Jul 30, 2006 07:27:42 ] |
Post subject: | |
OK, Well it was going to be my first try with them. I normally get the Bbue rubber sealed & always have good luck. I'll check on some of them. |
Author: | kant76 [ Sun Jul 30, 2006 11:46:30 ] |
Post subject: | |
Author: | WerxRacing [ Sun Jul 30, 2006 14:27:59 ] |
Post subject: | |
WOW... Thank you both for the advice & I'm going to start looking for the parts. I like to have somethigns done before it hits the road. |
Author: | irish [ Mon Jul 31, 2006 18:46:59 ] |
Post subject: | |
Author: | miko [ Tue Sep 05, 2006 02:12:08 ] |
Post subject: | |
Hi, I've been in the hobby for 20 years and looking to race on and off road, Just picked up my nt18 yesterday and all I can say is wow! I wasn't ready for this type of quality, it's second hand but only just run in, it's already got alloy driveshafts, front one way, 6 volt nimh and mg servo's all for $160- aus. I think it was a bargain and a fantastic car. Hold it on!! ![]() |
Author: | Keith [ Mon Sep 11, 2006 14:32:57 ] |
Post subject: | |
Page 1 of 1 | All times are UTC + 2 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |