New member with a NT18

WerxRacing · **Joined:** Thu Jul 27, 2006 21:20:51 **Posts:** 29

OK, 32people took a look, but no one can say HI or give good advice on fixing my NT18 up...........?

Later.

geezatec · **Posted:** Sat Jul 29, 2006 23:03:35

WerxRacing · **Joined:** Thu Jul 27, 2006 21:20:51 **Posts:** 29

Great info. I will have my car here in a few days. I just got a HPI Mustang Cobra body for it & going to start from there. I'm in Southern Indiana. I was thinking of going with sealed ceramic bearing to inprove speed & long life on it.

geezatec · **Posted:** Sun Jul 30, 2006 06:41:20

Kewl!! Ceramic brgs nice. I just had bad luck with them, on my Serpent 960. When they break. total failure. I wont use them again. My opinion only. It's cool!!

WerxRacing · **Joined:** Thu Jul 27, 2006 21:20:51 **Posts:** 29

OK, Well it was going to be my first try with them. I normally get the Bbue rubber sealed & always have good luck. I'll check on some of them.

kant76 · **Posted:** Sun Jul 30, 2006 11:46:30

WerxRacing · **Joined:** Thu Jul 27, 2006 21:20:51 **Posts:** 29

WOW... Thank you both for the advice & I'm going to start looking for the parts. I like to have somethigns done before it hits the road.

irish · **Posted:** Mon Jul 31, 2006 18:46:59

miko · **Joined:** Tue Sep 05, 2006 01:52:45 **Posts:** 1

Hi, I've been in the hobby for 20 years and looking to race on and off road,
Just picked up my nt18 yesterday and all I can say is wow!
I wasn't ready for this type of quality, it's second hand but only just run in, it's already got alloy driveshafts, front one way, 6 volt nimh and mg servo's all for $160- aus.
I think it was a bargain and a fantastic car.
Hold it on!!

Keith · **Posted:** Mon Sep 11, 2006 14:32:57

XRAY - Model racing cars

New member with a NT18

Who is online