| XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
| Sprektrum with a NT18T https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=18&t=3669 |
Page 1 of 2 |
| Author: | pimpingee [ Fri May 26, 2006 23:00:53 ] |
| Post subject: | Sprektrum with a NT18T |
| Author: | kant76 [ Sat May 27, 2006 00:24:25 ] |
| Post subject: | |
take off your on off switch, and solder some pluge on the batter wire. I have done this on bot my nt´s, not because I use spectrum, but because the switch broke after a week on both my cars. the reciver should never be in contact with the drive shaft at any time!!!!!! contact can damage both you resicer engine and bearings, so its a no go b4 you correct this. /kenn |
|
| Author: | geezatec [ Sat May 27, 2006 02:24:28 ] |
| Post subject: | |
Question is to have a switch or not??? Racers in the US like me Does away with switches. One reason, you crash it accidentally turn off your radio. Pigtail on Battery pack the same plug on the switch. So connect it straight to the Receiver. Do away with switch now you got more room to mount the receiver & room from the drive shaft. |
|
| Author: | pimpingee [ Sat May 27, 2006 08:25:39 ] |
| Post subject: | |
| Author: | geezatec [ Mon May 29, 2006 06:44:00 ] |
| Post subject: | |
| Author: | dangerousmouse [ Wed May 31, 2006 00:59:51 ] |
| Post subject: | |
just stumbled across this while looking around. spektrum micro receiver |
|
| Author: | Roelof [ Wed May 31, 2006 08:56:46 ] |
| Post subject: | |
| Author: | geezatec [ Wed May 31, 2006 09:55:43 ] |
| Post subject: | |
Probably using Pro Series system by Spektrum. Airtronics M8/M11 FM radio gear. Good choice!!!! |
|
| Author: | changss [ Wed May 31, 2006 16:24:49 ] |
| Post subject: | |
| Author: | geezatec [ Wed May 31, 2006 18:11:58 ] |
| Post subject: | |
| Author: | Roelof [ Thu Jun 01, 2006 11:24:59 ] |
| Post subject: | |
Spektrum is more than only some frequencies on a higher band. - the receiver only works on your transmitter (identification) - it is auto sensing and auto switching to use the best channel - it is completly digital - it has a build in failsafe - uses a shorter antenna, for those who do not want one outside the body Yes, it does use WiFi technoligy so olso I fear you could get no free channel in the middle of the citty within all those hotspots.... |
|
| Author: | pimpingee [ Thu Jun 01, 2006 22:51:13 ] |
| Post subject: | |
| Author: | geezatec [ Thu Jun 01, 2006 22:59:28 ] |
| Post subject: | |
| Author: | harshguy [ Mon Jul 24, 2006 17:36:48 ] |
| Post subject: | |
I just installed the new spektrum micro recvr, works great!! ...was able to mount it on top of the steering servo, and by doing so clearing out the entire area on the tray so I could mount a 1200MAH recvr pack, also was able to fit an on/off switch in there: |
|
| Author: | Str8tNitro [ Mon Jul 24, 2006 18:22:21 ] |
| Post subject: | |
Try standing it up, then being flat. Just as long u still have access the the Crystal. U really want the clearence for the center shaft. Sorry wrong thread!!! Look good though!! |
|
| Author: | Mark Harris [ Tue Jul 25, 2006 13:48:38 ] |
| Post subject: | |
| Author: | harshguy [ Wed Jul 26, 2006 17:45:16 ] |
| Post subject: | |
Here's a picture from the side: |
|
| Author: | Slammed94 [ Fri Jul 28, 2006 08:43:21 ] |
| Post subject: | |
What Tx are you using with that? |
|
| Author: | harshguy [ Fri Jul 28, 2006 21:31:30 ] |
| Post subject: | |
| Author: | Slammed94 [ Fri Jul 28, 2006 23:35:51 ] |
| Post subject: | |
Oh so you dont have to have a Spektrum Tx? If I have an Airtronics M3X-S will that work? |
|
| Page 1 of 2 | All times are UTC + 2 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|