Hey guys,
Some people were looking for a few picks in another post but off topic so here are some pics if you want others specify or any questions just ask me.
Part No. #199140
Answer to the first question:
Its Big!
68cm in length
45cm in width
70m in height.
The boxes are corrugated plastic with molded handles.
And high wear areas (areas of contact wear box meets the case) are covered by some sort of felt material which is smooth and I assume hard wearing.
Internal Lower car box measurements.
31.5cm in length
22.75cm in width
19cm in heigth
The other 3 boxes are 12cm in heigth.
The tool caddy (not really a case as it is not enclosed when detached) is detachable.
There are 2 carry handles which you can see in the pics as well as a 2 point telescopic handle for wheeling
Also 2 large zipped pockets either side for errr... setup board and shirts and jeans!??
I do have one question and thats what are the 2 square molded socket on the rear lower back near the axle? for an upright caddy of some sort or maybe a clip on larger wheels axle.
For wheeling within track grounds I would like to see ALL manufacturers supply or have as an option larger sack trolly/truck type inflateable wheels e.g. ---> PW Series (Plastic Centres) --> http://www.rosshandling.co.uk/assorted-wheels.asp
Its something I may make and be able to tighten onto the entire lower section. Practically all clubs do not have a smooth surface to pitting areas.
But thats not limited to this bag! thats all of them.
Hope you enjoyed the quick review andy questions just ask.
Regards,
Nick Brooker.
