XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
Hudy lathe https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=12&t=7148 |
Page 1 of 1 |
Author: | dragon26 [ Wed Feb 20, 2008 05:03:10 ] |
Post subject: | Hudy lathe |
Hi, I purchased a hudy tech lathe and am having some problems with it. When I cut a comm I am left with lines through the comm almost like ribs. The tip is not the issue as I've tried other tips and get the same results. I am running the slave motor at 5v. Thanks for any help. |
Author: | mario [ Wed Feb 20, 2008 11:07:37 ] |
Post subject: | |
Author: | Frans H [ Sat Feb 23, 2008 21:59:58 ] |
Post subject: | |
@Dragon26 suggestion 3 from Mario will normally cure your probs. Frans |
Page 1 of 1 | All times are UTC + 2 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |