| XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
| Hudy Drive Pin Removal Tool for 808 https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=12&t=10767 |
Page 1 of 1 |
| Author: | NickB [ Tue Aug 17, 2010 11:11:46 ] |
| Post subject: | Hudy Drive Pin Removal Tool for 808 |
Hey guys! Would be gratefull if someone could tell me the Part No. for the Pin that is in the actuall Tool. Its the one on the plunger piece of the removal tool that shattered on first usage!   I think ill try a vice to squeeze it instead of a hammer.Thanks in advance! Nick |
|
| Author: | RC America [ Tue Aug 17, 2010 22:38:31 ] |
| Post subject: | Re: Hudy Drive Pin Removal Tool for 808 |
Hi Nick, The replacement drive pin is #106035. Bryan |
|
| Author: | Robin Frischkopf [ Tue Aug 17, 2010 22:56:18 ] |
| Post subject: | Re: Hudy Drive Pin Removal Tool for 808 |
Hi Nick, if you want to compress it with the vise you better have an industrial one with a few tons of pressure.  When using the drive pin tool it all depends on the surface you use it on. On concrete it bounces, on wood it depresses. The best way to use it is actually to put it ontop of the vise (fixed to a workbench) or a similar large metal underplate of some sort. Like this it just takes a few hammer strokes. I do all 6 pins whenever I have the car apart and it only takes a few minutes. |
|
| Author: | martydoc [ Wed Aug 18, 2010 00:32:34 ] |
| Post subject: | Re: Hudy Drive Pin Removal Tool for 808 |
Hi Nick Ask Barkley to show you the pin removal tool he made next weekend when you are up for the national round. |
|
| Author: | Barkley Abernethy [ Wed Aug 18, 2010 00:44:56 ] |
| Post subject: | Re: Hudy Drive Pin Removal Tool for 808 |
bring them to national rd out of the car and ill do them sat morning if your up early enough . thats why i push rather than hammer .. that little pin broke my heart and the steel used is really hard to drill it out when it jams up in it .i had to bore a hole all the way down it . and holes drilled the right size so the pin dont break,and then pushes down to correct dept mr hudy you should make this . it compliments the pin tool so well ! |
|
| Author: | NickB [ Wed Aug 18, 2010 13:43:14 ] |
| Post subject: | Re: Hudy Drive Pin Removal Tool for 808 |
Cheers Barkley! Im not in a hurry this weekend what i had to do the last time was order in 2 new centre drive shafts! I will have a go a making the same tool you have at home, dad has a welder so thatll be a winter project for me to do. Ah I see youve modified the tool with a Hex Bolt and Hand grip v nice! All you need now is to anodize it! Cheers folks! Nick. |
|
| Author: | martydoc [ Thu Aug 19, 2010 00:37:42 ] |
| Post subject: | Re: Hudy Drive Pin Removal Tool for 808 |
You should start making them Barkley. I'd give you a tenner for one at a push 
|
|
| Page 1 of 1 | All times are UTC + 2 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|