Hello,
I've brought the ESC driveshafts for my Xray T3 2012. And when the driveshafts were new the pins didnt sticked out.
But now I've brought new pins (# 305390 & # 305391) and pins now stick out a little bit on each side (look at the picture)
They are too long for aprox. 0.5 mm each. Is this normal ?
File comment: Pins sticking out
P8050067_kode_resize.jpg [ 52.32 KiB | Viewed 4463 times ]
And there is alaso one mistake: in parts list of ESC driveshaft () it says that pins are 8.5mm & 9mm.
But in instruction manual of driveshafts it says 8mm & 9mm. (look at the picture)
File comment: Mistake
Snap1.jpg [ 31.58 KiB | Viewed 4463 times ]
Best regards
Jan Popic