Yes, Xray diffs are prebuilt, but they aren't set from the factory. You have to break and tighten them in manually. Glad it worked out.
| XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
| Just built my M18 PRO... Have a few questions on drifting... https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=11&t=8347 |
Page 1 of 1 |
| Author: | omastouris [ Fri Oct 10, 2008 18:14:38 ] |
| Post subject: | Just built my M18 PRO... Have a few questions on drifting... |
| Author: | Mini_Me [ Fri Oct 10, 2008 19:14:04 ] |
| Post subject: | |
| Author: | LimmetED [ Sat Oct 11, 2008 12:59:16 ] |
| Post subject: | |
| Author: | omastouris [ Sun Oct 12, 2008 22:44:27 ] |
| Post subject: | |
HI ALL, when i first assembled it together, i noticed that when i turn left on a stand-still , that the left wheel would raise, i alsi noticed that it was becuz of the rod that connecs the steering horn to the left side. i ended up tightening it all the way possible instead of the 56 mm that the instructions recomennd. my steering is ok now , i guess, at least there is no wheel lift either left or right. i have the brace with all 6 screws on,NOW i will try to loosen the brace as u said , but then why would it drift turning left and not turning right ? it just oversteers when i try to drift towards the right.thanx for all the responses. p.s. to everybody : what mods have u done to ur M18 PRO ? |
|
| Author: | Mini_Me [ Mon Oct 13, 2008 02:30:52 ] |
| Post subject: | |
| Author: | omastouris [ Wed Oct 15, 2008 08:48:30 ] |
| Post subject: | |
**** UPDATE **** OK, So i checked and adjusted my droop screws, they were only off a little bit but now they are ok.i tried tightening the diff's and it still will only spin out when i turn towards the left but not the right.i know there is something wrong for sure becuz of this, it oversteers when i turn right and i am giving it juice. i am lost, is there anybody i can PM that might now more on this.? i just wanna make this thing perfect. thanx all. |
|
| Author: | Mini_Me [ Wed Oct 15, 2008 23:45:18 ] |
| Post subject: | |
There is something your probably overlooking. But without looking at the car and your electronics setup, I cant tell. Is there a hobby shop in your area that might have someone knowledgeable to give it a look over just to see if its built and working right without any binding (which is what sounds like might be happening). That or maybe a track that they can look over it between heats? |
|
| Author: | omastouris [ Mon Oct 27, 2008 03:46:37 ] |
| Post subject: | finally got it drifting..... |
| Author: | Mini_Me [ Mon Oct 27, 2008 06:04:43 ] |
| Post subject: | |
Yes, Xray diffs are prebuilt, but they aren't set from the factory. You have to break and tighten them in manually. Glad it worked out.
|
|
| Page 1 of 1 | All times are UTC + 2 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|