XRAY - Model racing cars

HI ALL,
when i first assembled it together, i noticed that when i turn left on a stand-still , that the left wheel would raise, i alsi noticed that it was becuz of the rod that connecs the steering horn to the left side.
i ended up tightening it all the way possible instead of the 56 mm that the instructions recomennd. my steering is ok now , i guess, at least there is no wheel lift either left or right.
i have the brace with all 6 screws on,NOW i will try to loosen the brace as u said , but then why would it drift turning left and not turning right ? it just oversteers when i try to drift towards the right.thanx for all the responses.

p.s. to everybody : what mods have u done to ur M18 PRO ?

**** UPDATE ****

OK, So i checked and adjusted my droop screws, they were only off a little bit but now they are ok.i tried tightening the diff's and it still will only spin out when i turn towards the left but not the right.i know there is something wrong for sure becuz of this, it oversteers when i turn right and i am giving it juice.
i am lost, is there anybody i can PM that might now more on this.? i just wanna make this thing perfect. thanx all.

There is something your probably overlooking. But without looking at the car and your electronics setup, I cant tell.

Is there a hobby shop in your area that might have someone knowledgeable to give it a look over just to see if its built and working right without any binding (which is what sounds like might be happening). That or maybe a track that they can look over it between heats?

Yes, Xray diffs are prebuilt, but they aren't set from the factory. You have to break and tighten them in manually. Glad it worked out.