Hello there Im new in the 1/18 scale. Firstly, i want to thank Xray for the amazing chassis design. The workmanship was brilliant and the design is wonderful. I have been running the car on my local hobbyshop.
What i found out is that when i go into a turn it and upon exiting it alwiz spin out. Im running Hard compound at the front and soft at the rear (foam tyres). Is there a remedy for that. (original kit recommendation)
Some guys say my power is too much for the servo to handle. Im using a hitec 85MG. and running a 6800Kv Mamba motor, 6 degree caster, 4mm ride height front n back. double ball diff.
The track that im running is a medium traction asphalt track.
Hope someone can give me some insight tips for this
|