| XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
| New Tires and the M18 tilts https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=11&t=6994 |
Page 1 of 1 |
| Author: | dirkrs [ Sat Jan 26, 2008 11:17:50 ] |
| Post subject: | New Tires and the M18 tilts |
| Author: | Mini_Me [ Sun Jan 27, 2008 21:54:36 ] |
| Post subject: | |
New foams always have this. You need to break them in about 1.5 mm to get to the "sweet" spot. 50 shore fronts are less likely to encounter this, but they wear faster and wont give you as much steering. Here is a thread on the subject. viewtopic.php?t=5460 |
|
| Author: | dirkrs [ Sun Jan 27, 2008 22:44:51 ] |
| Post subject: | |
Thanks, I read your Thread. I understand it so that I sand off new tires down to 34.3 - 34.6mm. And a round edge of 1,5mm spreads.Then they works "fine"! What about the ride height? How adjust? Mini_Me: can i send you a photo of my tires? Please send me your e-mail adress per PM?! Better understand which I mean! Thanks Dirk |
|
| Author: | Mini_Me [ Sun Jan 27, 2008 22:52:41 ] |
| Post subject: | |
I wouldnt round my tires personally. When you round them, you give them more side grip in corners, so they can traction roll more. Maybe round the rears, and leave the front flat. Im pretty sure I understand what you mean. As far as ride height, stock, you use the droop screws to adjust. (The screws that go in the a-arms. |
|
| Page 1 of 1 | All times are UTC + 2 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|