| XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
| Dirt cover for the M18MT https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=11&t=5175 |
Page 1 of 1 |
| Author: | andy41279 [ Fri Mar 16, 2007 21:00:49 ] |
| Post subject: | Dirt cover for the M18MT |
| Author: | GroundHog [ Fri Mar 16, 2007 22:37:55 ] |
| Post subject: | |
| Author: | andy41279 [ Sat Mar 17, 2007 01:25:28 ] |
| Post subject: | |
| Author: | Mini_Me [ Sat Mar 17, 2007 05:47:49 ] |
| Post subject: | |
By hardened spur, were you referring to the ? |
|
| Author: | andy41279 [ Sat Mar 17, 2007 11:58:37 ] |
| Post subject: | |
No, I meant the plastic one with the "H" on it. I know there is a steel version of the spur gear. I haven't tried it so far. Still, I'd like to keep stones and dirt OUT of my car. At least most of it. My main drive shaft has already been grinded down near the spur gear so that it's a lot thinner now. Stones get trapped between the battery pack/the chassis and the drive shaft and wear down the drive shaft. I can't run a full battery pack without trouble. |
|
| Author: | Tyrefryer [ Sat Mar 17, 2007 12:42:58 ] |
| Post subject: | |
hi I have ordered the Micro Body 1/18 MT - Cadillac #389761 but became the Micro Body 1/18 NITRO MT #389762 & my dealer told me, that the Cadillac Body is no longer available 
this NITRO Body is already cut out, unfortunately very generous 
so I am also a little concerned, about stones getting jammed at the Spur Gear
|
|
| Author: | andy41279 [ Sat Mar 17, 2007 13:24:39 ] |
| Post subject: | |
Closing the gap between the chassis and the body helps a little, but it's not enough. A well-designed lexan cover over the chassis and under the body would play the trick I'm sure. It could have holes for the steering rods, the antenna and the motor cooler and still keep dirt and stones (and snow) outside. To fix it to the (plastic) chassis you could drill holes through the side walls. Kyosho has such a one on their Mini Inferno ST. Come on Xray! |
|
| Author: | Mini_Me [ Sat Mar 17, 2007 19:03:07 ] |
| Post subject: | |
| Author: | andy41279 [ Tue Mar 20, 2007 15:37:08 ] |
| Post subject: | |
| Page 1 of 1 | All times are UTC + 2 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|