| XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
| M18 Pro wheel nut size? https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=11&t=5118 |
Page 1 of 1 |
| Author: | outfitter540 [ Sun Mar 04, 2007 22:39:31 ] |
| Post subject: | M18 Pro wheel nut size? |
| Author: | Mini_Me [ Mon Mar 05, 2007 03:27:40 ] |
| Post subject: | |
Sorry thought you meant the m18t The dimensions are...6mm I.D. 2.5mm thick. 7.95 on flat outer side, while ~ 9mm on edge. |
|
| Author: | orangedonkey [ Tue Mar 06, 2007 01:47:34 ] |
| Post subject: | |
| Author: | brano [ Tue Mar 06, 2007 08:21:25 ] |
| Post subject: | |
| Author: | outfitter540 [ Wed Mar 07, 2007 06:28:13 ] |
| Post subject: | |
well i went to the hardware store to see if i could find some replacement nuts (30 cents is a lot better than 2.50 per nut just so you know) i tried threading it on to a m6 bolt and it would not thread on. the only screw it would thread on is a 1/4-20, but that was very loos and not a good fit. If anyone could tell me the pitch like m1,m2,m3 etc that would be great. edit: the bolt i tried was a m6-1.0 i assume the 1.0 is the pitch? so i would be looking for a m6-0.75? |
|
| Author: | Acid [ Wed Mar 07, 2007 11:42:32 ] |
| Post subject: | |
M6x0,75 is what are you looking for M6 means it is metric thread on diameter 6mm (its biggest diameter) x0,75 means that it is not standart pitch for M6, but its fine pitch, in this case 0,75mm threads with standart pitch are marked just M6 and pitch in this case is 1mm |
|
| Page 1 of 1 | All times are UTC + 2 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|