XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
M18T steering linkage problem https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=11&t=4110 |
Page 1 of 1 |
Author: | lotter [ Fri Aug 25, 2006 01:02:05 ] |
Post subject: | M18T steering linkage problem |
Hi, i build up my new new M18T and i loved it ![]() But i have a single problem with the steering linkage. The lower screws reach the plastic cup of the diff output. Which makes the steering "a bit" inacurate ![]() I think the ballbearings in the steering arm have to much clearance themselves!? take a look: Can you help me? Is there a workaround? thanks |
Author: | Roelof [ Fri Aug 25, 2006 06:52:09 ] |
Post subject: | |
You can raise the upperdeck by placing some washers under it at the screws. |
Author: | brano [ Fri Aug 25, 2006 08:39:18 ] |
Post subject: | |
I suggest you will tighten the M3x10 screw that holds the bearings in steering arm together with the top deck. |
Author: | Mini_Me [ Fri Aug 25, 2006 10:20:06 ] |
Post subject: | |
You might also check to see if your using the 2.2X8 screw versus a 2.5 which would have a bigger head. |
Author: | lotter [ Fri Aug 25, 2006 21:24:55 ] |
Post subject: | |
Page 1 of 1 | All times are UTC + 2 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |