| XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
| Question regarding the Alu Drive Shaft M18T - Set (2) https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=11&t=3758 |
Page 1 of 1 |
| Author: | AUG [ Sat Jun 10, 2006 04:56:23 ] |
| Post subject: | Question regarding the Alu Drive Shaft M18T - Set (2) |
| Author: | AUG [ Mon Jun 12, 2006 02:57:32 ] |
| Post subject: | |
| Author: | Mini_Me [ Mon Jun 12, 2006 09:19:27 ] |
| Post subject: | |
| Author: | brano [ Mon Jun 12, 2006 09:43:50 ] |
| Post subject: | |
XRAY has made a running change, the two piece alu drive shafts are the newer version. |
|
| Author: | AUG [ Mon Jun 12, 2006 17:06:12 ] |
| Post subject: | |
Thanks brano! That's what i figured since it would be less likely to strip the threads by using a stronger material, I just wished you used stainless steel hex's but I also understand that SS is weaker. Mini_Me, give me an e-mail address and ill send you a couple pictures. It would be faster that way since I wouldn't have to find a place to host them. Thanks for the reply - AUG[/img] |
|
| Page 1 of 1 | All times are UTC + 2 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|