XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
Yesterday: hard work mounting new options https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=11&t=3397 |
Page 1 of 1 |
Author: | setecastronomy [ Mon Apr 10, 2006 14:54:32 ] |
Post subject: | Yesterday: hard work mounting new options |
Yesterday my wife was working at the polling station (Berlusconi ! Time to go home !) so I spent entire afternoon mounting the new option parts on my M18T. I have bought the suspension blocks from 3Racing and the hex adapters and pinions from Xray. Mounting the suspension blocks I noticed that a ball bearing was damaged but I was anxious to test the new configuration so I went on. The hex adapters are fantastic compared with my hand made fimo adapters. I tryed to put a 19 teeth pinion but it was too tight on the spur: unfortunately there is not enough space so I have to give up my dream of super speed with a 23 teeth pinion. When finally the truck was ready with a 17 teeth I drove it outside. Unfortunately the ball bearing deteriorated very fast and the behaviour of the truck was impredictable because sometimes the rear wheel blocked causing it to spin or roll on its roof. It was funny when it rolled at full speed and moved more than 10 meters on its roof before stopping. About the front suspension blocks: I'm a bit worried becuase it seems that there is some bump steering because 3Racing doesn't have the top extension on page 22 of the manual on the knuckle. Besides I don't have the right screw to fix the bottom extension on page 22 of the manual on the knuckle. Hoping to find the ball bearing soon. Bye Filippo |
Author: | mario [ Mon Apr 10, 2006 17:16:47 ] |
Post subject: | |
Page 1 of 1 | All times are UTC + 2 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |