18T power systems

scmicromike · **Joined:** Fri Oct 08, 2004 22:27:11 **Posts:** 45

I will take a stab at this. I know that the 300 and 370 motor fits properly, I dont know about anything else though since I havent tryed any other. Mike

Mini_Me · **Posted:** Tue Feb 28, 2006 23:04:50

sgarvin · **Joined:** Fri Sep 10, 2004 13:21:40 **Posts:** 97

I know the alu motor mount is drilled for 300's, but II was looking for brand names. For example, the Mamba systems work, or the Tekin systems work etc...

builthatch · **Posted:** Wed Mar 01, 2006 01:50:03

well, i know for a fact the Mass Term motor bolt up and also this new (to my car) mini machine 17t does as well; it's the same can as the mass termination.

Cambridgenorth · **Joined:** Fri Dec 30, 2005 04:49:05 **Posts:** 37

I have the alu motor mount from Xray and the Mamba 6800.

The fit is not quite right and I did not want to have to drill/elongate the holes - the mount is too nice to carve it up in any way.

I put each screw in only enough to grab initially and then tightened them down a turn each alternately until they were both fully seated.

It worked OK - probably did a little scouring on eiher the screws or the mounts, but nothing serious.

Hope this helps.

sgarvin · **Joined:** Fri Sep 10, 2004 13:21:40 **Posts:** 97

scmicromike · **Joined:** Fri Oct 08, 2004 22:27:11 **Posts:** 45

Here is my thought, with the stock motor (300/370) and 6 cells I believe it is plenty fast. granit I only run on a tiny track in my back yard, a 16'X20' figure 8, But I am also geared with smallest pinion I got. On a 45X60 track I might get a bit board and want something faster, but I dont think I will ever get to out of hand. Mike

Cambridgenorth · **Joined:** Fri Dec 30, 2005 04:49:05 **Posts:** 37

sgarvin · **Joined:** Fri Sep 10, 2004 13:21:40 **Posts:** 97

Mini_Me · **Posted:** Fri Mar 03, 2006 09:06:21

You will probably want to invest in the if you plan to run a mamba.

XRAY - Model racing cars

18T power systems

Who is online