| XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
| Problems? https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=11&t=2518 |
Page 1 of 1 |
| Author: | James Pike [ Wed Nov 02, 2005 19:09:00 ] |
| Post subject: | Problems? |
| Author: | Mini_Me [ Wed Nov 02, 2005 21:01:06 ] |
| Post subject: | |
Unscrew the servo horn and take it off. Let the servo center itself, and attach the horm again with this centering on. Check to make sure your radio isn't in reverse trim. |
|
| Author: | James Pike [ Wed Nov 02, 2005 21:11:23 ] |
| Post subject: | |
Its in reverse trim because thats how it is on my T1R. So I put it to every trim position but it still goes in reverse. The servo is in the neutral postion, I can turn to full lock left and right. I adjusted the trim on the sterring but it still stays to that one side. I cant think of anything else I can do to make it right. |
|
| Author: | Mini_Me [ Wed Nov 02, 2005 21:26:45 ] |
| Post subject: | |
Well maybe Im not understanding. Is your car on the ground going in reverse and to the right? Is the throttle jittering or your steering jittering. If your steering servo is centered, and you then played the servo horn on after it was centered, Im not sure what you mean it points to the right? |
|
| Author: | James Pike [ Wed Nov 02, 2005 21:46:12 ] |
| Post subject: | |
| Author: | Mini_Me [ Wed Nov 02, 2005 21:58:17 ] |
| Post subject: | |
| Author: | James Pike [ Wed Nov 02, 2005 22:09:28 ] |
| Post subject: | |
| Author: | Gumby_Mac [ Wed Nov 02, 2005 22:25:57 ] |
| Post subject: | |
| Author: | James Pike [ Thu Nov 03, 2005 09:52:12 ] |
| Post subject: | |
Just push something sharp in (I used a compass) very gently so as not to damage it. Push on the exposed silver bit you can see at the side. The gently pull the wire and it will come out. Then just click it back into the correct side, its very easy. |
|
| Author: | Gumby_Mac [ Sat Nov 05, 2005 00:18:19 ] |
| Post subject: | |
| Author: | James Pike [ Sat Nov 05, 2005 11:25:36 ] |
| Post subject: | |
| Page 1 of 1 | All times are UTC + 2 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|