XRAY - Model racing cars

Unscrew the servo horn and take it off. Let the servo center itself, and attach the horm again with this centering on.

Check to make sure your radio isn't in reverse trim.

Its in reverse trim because thats how it is on my T1R.

So I put it to every trim position but it still goes in reverse. The servo is in the neutral postion, I can turn to full lock left and right. I adjusted the trim on the sterring but it still stays to that one side.

I cant think of anything else I can do to make it right.

Well maybe Im not understanding. Is your car on the ground going in reverse and to the right? Is the throttle jittering or your steering jittering.

If your steering servo is centered, and you then played the servo horn on after it was centered, Im not sure what you mean it points to the right?

Just push something sharp in (I used a compass) very gently so as not to damage it. Push on the exposed silver bit you can see at the side. The gently pull the wire and it will come out. Then just click it back into the correct side, its very easy.