| XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
| Putting the wheels on https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=11&t=2495 |
Page 1 of 1 |
| Author: | James Pike [ Fri Oct 28, 2005 20:52:27 ] |
| Post subject: | Putting the wheels on |
| Author: | minimad [ Fri Oct 28, 2005 23:50:11 ] |
| Post subject: | |
| Author: | Mini_Me [ Sat Oct 29, 2005 04:04:56 ] |
| Post subject: | |
| Author: | James Pike [ Sat Oct 29, 2005 10:09:57 ] |
| Post subject: | |
| Author: | ChrisP [ Sat Oct 29, 2005 18:29:38 ] |
| Post subject: | |
| Author: | Mini_Me [ Sat Oct 29, 2005 22:49:40 ] |
| Post subject: | |
Good suggestion Chris. I suspected the same thing, however I can say finding a metric m3 tap locally is quite hard. |
|
| Author: | ChrisP [ Sun Oct 30, 2005 06:30:18 ] |
| Post subject: | |
| Author: | minimad [ Sun Oct 30, 2005 09:17:35 ] |
| Post subject: | |
| Author: | James Pike [ Sun Oct 30, 2005 10:09:22 ] |
| Post subject: | |
Yeah, it was the M18 I meant. I had the groves all in line but it was still a tight fit. And when you pushed with fingers the edges dug in and really hurt, making it even harder to get on. I just put a metal ruler over the edge and pressed down on it as hard as I could and they went on bit by bit. |
|
| Author: | minimad [ Sun Oct 30, 2005 10:22:57 ] |
| Post subject: | |
as long as you realise some of the grooves go all the way and some dont. it is a tight fit, but they seem strong enough to take a bit of pulling and pushing. at least they dont come off mid race:) |
|
| Author: | James Pike [ Sun Oct 30, 2005 10:32:05 ] |
| Post subject: | |
| Author: | minimad [ Sun Oct 30, 2005 22:29:30 ] |
| Post subject: | |
just changes the track width of your car slightly, either is ok. |
|
| Page 1 of 1 | All times are UTC + 2 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|