XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
Driveshaft pinion gear: Front & Rear fully consumed in 1 https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=11&t=245 |
Page 1 of 1 |
Author: | e_lm_70 [ Mon Oct 11, 2004 12:56:20 ] |
Post subject: | Driveshaft pinion gear: Front & Rear fully consumed in 1 |
Author: | oXYnary [ Tue Oct 12, 2004 01:51:29 ] |
Post subject: | |
Author: | brano [ Tue Oct 12, 2004 07:03:31 ] |
Post subject: | Re: Driveshaft pinion gear: Front & Rear fully consumed |
Author: | Nelly [ Tue Oct 12, 2004 08:04:39 ] |
Post subject: | |
Author: | oXYnary [ Tue Oct 12, 2004 08:27:51 ] |
Post subject: | |
Author: | Nelly [ Tue Oct 12, 2004 08:48:25 ] |
Post subject: | |
Author: | e_lm_70 [ Tue Oct 12, 2004 09:45:46 ] |
Post subject: | |
Author: | Nelly [ Tue Oct 12, 2004 09:53:31 ] |
Post subject: | |
Author: | oXYnary [ Tue Oct 12, 2004 12:17:06 ] |
Post subject: | |
Author: | e_lm_70 [ Tue Oct 12, 2004 12:54:55 ] |
Post subject: | |
Author: | e_lm_70 [ Tue Oct 12, 2004 13:28:06 ] |
Post subject: | |
Author: | billdapart [ Wed Oct 13, 2004 20:03:49 ] |
Post subject: | small fix |
I had the exact same problem. 3cell apogee pack and mamba 8000.. After taking apart the diffs and replacing the shaft gears, I put the two small silver washers both on the opposite side of the teeth for the main diff gear.. this seems to have corrected the small bit of lash in the mesh and I haven't had a problem since. of course, an aluminum replacement sure would be swell... hint, hint |
Author: | masko [ Fri Jul 12, 2019 14:49:18 ] |
Post subject: | Re: |
Author: | johnricher [ Wed Jul 24, 2019 16:57:48 ] |
Post subject: | Re: Driveshaft pinion gear: Front & Rear fully consumed in 1 |
Author: | dadi01 [ Fri Oct 25, 2019 18:53:44 ] |
Post subject: | Re: small fix |
Author: | EmmaDavis [ Fri Nov 08, 2019 07:21:48 ] |
Post subject: | Re: Driveshaft pinion gear: Front & Rear fully consumed in 1 |
Great information, thank you for that. In case you're facing problems related to JioFi device then do visit the site: |
Page 1 of 1 | All times are UTC + 2 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |