| XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
| SERVO https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=11&t=2304 |
Page 1 of 1 |
| Author: | bigb [ Thu Sep 29, 2005 23:17:48 ] |
| Post subject: | SERVO |
| Author: | oXYnary [ Fri Sep 30, 2005 08:28:40 ] |
| Post subject: | |
The Xray one is part #XMS01MG With the stock ears, you need one around the same dimensions in width which are... 1.2 x 0.5 x 1.2" 30 x 12 x 30 mm (so ie the 30 mm) Hitec 81MG is another. Without the stock ears, meaning you servo tape and shoo-goo your servo into place, your choices widen, BUT remember that the servo saver only comes with a few spline choices. I have heard that some of the JR and KO mini digital (really for 1/12th) work as well, but you have to cut their ears off to fit. Otherwise you can go smaller such as the Hitec HS-56B, but you will have to tape that in, and the smaller servos dont have as much torque (I have no idea what the torque requirements are for a mini truck). We should start a list (if this is ok?)... Be good for the FAQ Im building. |
|
| Author: | Wayne Mah [ Sun Oct 02, 2005 19:58:39 ] |
| Post subject: | |
HS85mg fits fine, just need to dremel the top of the ears. |
|
| Author: | Hades [ Thu Oct 06, 2005 19:18:57 ] |
| Post subject: | |
Dude, how did you get the HS85MG in? The centre of the axis is not at the right place.. or is it just me?? Thanks! |
|
| Author: | Mini_Me [ Thu Oct 06, 2005 20:58:59 ] |
| Post subject: | |
With center of axis, do you mean it doesn't line up with the servo saver indent? |
|
| Author: | alfreddajero [ Tue Oct 11, 2005 04:19:28 ] |
| Post subject: | |
| Author: | Hades [ Tue Oct 11, 2005 22:01:37 ] |
| Post subject: | |
The center of the axis is not at the same place on the 85 and on the 81. Plus, the distance between the fixing point and the end of the servo-saver is greater on the 85 than on the 81. My guess is that you'll have to add a washer or two between the servo holder and the servo to make it fit on the M18. |
|
| Author: | canada_m18t [ Thu Oct 27, 2005 08:56:55 ] |
| Post subject: | |
| Author: | Thugs Bunny [ Fri Feb 24, 2006 06:50:44 ] |
| Post subject: | JR z3550 but need faster!! |
| Author: | NateB8 [ Fri Feb 24, 2006 08:00:56 ] |
| Post subject: | |
| Author: | scmicromike [ Sun Feb 26, 2006 02:05:04 ] |
| Post subject: | |
| Page 1 of 1 | All times are UTC + 2 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|