XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
Assembly - Can't fit bearings https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=11&t=228 |
Page 1 of 1 |
Author: | jas [ Fri Oct 08, 2004 15:00:58 ] |
Post subject: | Assembly - Can't fit bearings |
Hi fellows, I am having trouble fitting the 10x6x3 bearings on to the "composite gear diff. + drive shaft pinion gear" (385000), it is the part that comes out from the gear box and where the middle drive shaft will be attached. Either the bearings are too small or the part is too large. I can't fit the bearings over it even with substantial force. This is not to be expected of a kit from XRay. Anyone of you also had this problem? Thanks! jas |
Author: | Qlone [ Mon Oct 25, 2004 01:03:09 ] |
Post subject: | |
Author: | jas [ Wed Oct 27, 2004 19:19:11 ] |
Post subject: | |
Yeah, I had to "hammer" them in, while try to damage the bearings. And XRay acknowledged the problem with a news release. |
Author: | Roelof [ Wed Oct 27, 2004 19:53:23 ] |
Post subject: | |
And in the wheelblocks they fit to lose ![]() |
Author: | brano [ Thu Oct 28, 2004 06:52:14 ] |
Post subject: | Re: Assembly - Can't fit bearings |
Page 1 of 1 | All times are UTC + 2 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |