XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
Rear diff. https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=11&t=1669 |
Page 1 of 1 |
Author: | Slava [ Tue May 24, 2005 12:09:10 ] |
Post subject: | Rear diff. |
After installing 300 motor I can achieve much bigger speeds. But while I braking car is turning 180 degree and big noise start to come from the diffs. After two batteries I have opened the rear diff and find out that metal shaft not at the center of the gear and some teeth of gear is gone in very strange way - seems like pinon fired them. Later investigation shows that whole unit bends under stress loads and pinon start to scratch gear instead of being firmly connected. What can be a solution? Ball diff? |
Author: | oXYnary [ Tue May 24, 2005 13:28:59 ] |
Post subject: | |
Yes, ball diff. However, if you can find an older front diff (the one you tightened with a screw) this could be a temp solution |
Author: | S. Slazak [ Thu Jun 02, 2005 11:30:03 ] |
Post subject: | |
Page 1 of 1 | All times are UTC + 2 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |