| XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
| m18 upgrade to Hex Wheel system https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=11&t=10182 |
Page 1 of 1 |
| Author: | visual_rabbi [ Fri Feb 12, 2010 01:41:54 ] |
| Post subject: | m18 upgrade to Hex Wheel system |
Is this all I need to upgrade an m18 to the Hex Wheel Nut System? XRAY Composite Drive Shaft http://www.amainhobbies.com/product_inf ... haft-Set-2 AND, what are the correct specs and resources to use for tires? I understand the front is 14mm and the rear is 17mm. |
|
| Author: | Thistle [ Fri Feb 12, 2010 04:19:42 ] |
| Post subject: | |
No, what you will need are: 2 packages of these http://www.amainhobbies.com/product_inf ... Adaptor--2 or these http://www.amainhobbies.com/product_inf ... -Adapter-2 and 2 packages of these http://www.amainhobbies.com/product_inf ... heel-Nut-2 I can't help you with tires, as I just run the mounted foam tires. |
|
| Author: | visual_rabbi [ Fri Feb 12, 2010 04:26:00 ] |
| Post subject: | thanks |
Got it. That's what I thought. AmainHobbies couldn't give me a definitive answer. |
|
| Author: | Robin Frischkopf [ Fri Feb 12, 2010 11:42:02 ] |
| Post subject: | |
You don't really need new driveshafts. You can use your old ones but you will have to sand them a little to fit into the new hex hubs. |
|
| Page 1 of 1 | All times are UTC + 2 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|