| XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
| XRAY M18T General Forum https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=11&t=2262 |
Page 8 of 8 |
| Author: | Roelof [ Sat May 16, 2009 09:03:50 ] |
| Post subject: | |
| Author: | Thomas P [ Thu Oct 29, 2009 21:29:12 ] |
| Post subject: | |
A useful tip reinforced arms...they WILL hold much better... "Bearthread" CA, and last epoxy...do not overthight when reaching the "Y" on the arm, it will cause "bind" |
|
| Author: | jermpool [ Sat Apr 03, 2010 20:08:50 ] |
| Post subject: | |
| Author: | Mini_Me [ Tue Apr 06, 2010 14:13:44 ] |
| Post subject: | |
It helps keep the steering knuckles from moving to far an angle and binding/locking the system. |
|
| Author: | jermpool [ Tue Apr 06, 2010 23:01:33 ] |
| Post subject: | |
Thank You |
|
| Author: | f1n3sse [ Sat Apr 16, 2011 17:59:53 ] |
| Post subject: | Re: XRAY M18T General Forum |
you don't need to put those 7mm spacers on the bottom of your steering knuckles if you set your epas correctly |
|
| Author: | f1n3sse [ Sat Apr 16, 2011 18:02:12 ] |
| Post subject: | Re: XRAY M18T General Forum |
Does anyone have a small list of 2s lipos that will fit the m18t without chassis modification? I have 2 brand new zippy 2s 40c 2200mah packs that are a bit too big. I'd like to not have to dremel the side wall off of the new chassis if possible but am looking for the highest capacity lipo at 30c or higher that will fit. any suggestions? |
|
| Author: | TpParts RcXtreme [ Sat Aug 03, 2019 10:36:37 ] |
| Post subject: | Re: XRAY M18T General Forum |
I took out one of the 2 M18Ts.. ( 1/18 and the other is a 1/16 ) But cant find what oil in shocks to be used..dont remember.. tarmac, mini pin tired |
|
| Author: | EmmaDavis [ Fri Nov 08, 2019 11:17:06 ] |
| Post subject: | Re: XRAY M18T General Forum |
Facing problems in JioFi login? Simply open any browser and enter and then simply click on login button and use administrator as username and password and this way you can simply login to JioFiLocalHtml. |
|
| Page 8 of 8 | All times are UTC + 2 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|